At (or Near) Wholesale Prices: Happy Product - Sad Box >
Give Us A Call
615-373-1444

10am - 4pm CST
Results 1 to 4 of 4

Thread: erc receiver servo board...

  1. #1

    erc receiver servo board...

    Hi, there again!!

    Just received my two new eRC receiver servo boards and motors for my other projects. However they don't give instructions on how to connect the motor to the receiver(This may be very obvious for many but I am a rookie and I don't want to burn out anything here!!) and also how to bind the new setup to my existing eRC P-51 Ridge runner Transmitter.

    Also 1-can I connect Any micro servo to this board or should I purchase a specific one?
    2-What type of music wire should I use for the control rods?
    3-How could I make this link adjustable?

    Any ideas will be greatly appreciated.

    Please advise if possible in step by step instructions on how to use this micro marvels in my other two projects (A Grumman American AA-1B TR-2 and a micro scale Shoestring).

    Again, many thanks

    Turbopropdriver :geek:

  2. #2
    Senior Member Jay Burkart's Avatar
    Join Date
    Jun 2009
    Location
    Smithfield KY
    Posts
    214

    Re: erc receiver servo board...

    I have an issue as we have done NO experimentation with this board at all.
    So I can only hazard some opinions and guesses.
    We do not really mean for the board to be purchased and used for application other than a replacement
    for a defective board in the Spitfire or P-51.
    As we discussed earlier in another thread you are doing what a modeler experimenter does when'
    coming up with a new application for a stock piece of model.

    I imagine that any micro servo will plug into the socket. The way servos are wired if you plug it in backwards it
    should not harm it, so try both ways.
    I do not know what you mean about hooking the motor to the receiver. There is a two wire connector that comes
    out of the board and that is meant to plug into the motor. If it turns the wrong way just reverse the connection.

    The binding instructions are in the instruction manual for the P-51 or Spitfire instructions.
    top of page 3.

    On the control rods, I do not experiment with micro models, take a look at the Micro RC models informatioin
    on Ezonemag.com in the discussions threards for them.

    Regards,
    Jay Burkart
    SAM Grand Champion 2004.07,10,12

  3. #3
    Senior Member Jay Burkart's Avatar
    Join Date
    Jun 2009
    Location
    Smithfield KY
    Posts
    214

    Re: erc receiver servo board...

    TPD

    Here is another link for a good resource for micro models and his link page.

    http://www.bsdmicrorc.com/index.php

    This should give you more resources to find the information you need.
    Regards,
    Jay
    SAM Grand Champion 2004.07,10,12

  4. #4

    Re: erc receiver servo board...

    Jay,

    Again many thanks and I will contact BSD now..

    Have a great one and I will send you snaphots of my creations with the board once I complete them..

    Rafael

    Turbopropdriver :ugeek:

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •